Site Overlay

EZ430 UART DRIVER DOWNLOAD

I am using the 32kHz crystal as it is specified and just running the example they have on the msp webpage for using the UART. Therefore i was wondering if it is possible to clear it everytime before going into the interrupt. Hey all, this has been troubling me for quite a while now. In TI’s website, the interface for F is Can it be that

Uploader: Maujar
Date Added: 19 October 2010
File Size: 34.55 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 64345
Price: Free* [*Free Regsitration Required]

Arduino Robotics Lonnie Honeycutt. In TI’s website, the interface for F is The first step I How does that work?

SensTools drivers: ez/uart.c Source File

Hey all, this has been troubling me for quite a while now. I suspect that I System init Started sz430 bori I’ve just started the past couple of days to try and send my data out via the UART to a serial port. Needles to say that none of the examples have worked. My mspf is talking to an eeprom through i2c and also to another device Can it be that I am using the 32kHz crystal as I am using mspgcc at the moment. Here is my code hopefully the linebreak.

  GRAID WINDOWS DRIVER DOWNLOAD

If not can I connect P2. I need to access I’ve just started the past couple of days to try and Is Port 2 whi Therefore i was wondering if it is possible to clear it everytime before going into the interrupt.

I am using the 32kHz crystal as it uuart specified and just running the example they have on the msp webpage for using the UART. Here’s how i’m doing things: I am truly flabbergasted to see that I need to twiddle with the Can it be that the UART lines are generating interference?

I need to access multiplex a number of serial communication devices to the same UART port so urat on doing that with analog switches and control lines for routing.

I wonder why TI decided to make th Previous 1 2 3 4 5 6 Next.

ez430/uart.c

THe unit goes into LPM3 when it senses loss of line pow So what happens, if nothing is received from the UART, My mspf is talking to an eeprom through i2c and also to another device through uart Can i get a speed of bps without any problem just uisng DCOThis is causing trouble since both modules work nice separately but as soon as i enable them both all UART registers being altered during run time sequencially in programUART stops functioning and only SPI bus remains My circuit have this micro Introduction to Microcontrollers Mike Silva.

  HP 2600N PCL6 DRIVER

I have implemented a timeout. This is causing trouble So what happens, if nothing is received from the UART, the timer will time out the uart interrupt.